Lexicon RV-8 User Manual page 198

Appendix C
7. Repeat from step 3 until you have programmed all of the
Macros that you require.
8. When programming is complete, press the HOME button. Exit
from the SETUP mode by pressing the HOME button once
again.
Note:
The M1, M2, M3, POWER and SYSTEM OFF macros
are system-wide, which means they will function the
same no matter what device is being used when they
are programmed.
Programming Macro Functions to the Ten Device
Buttons
To program Macro function to the 10 device buttons:
1. Go to the SETUP mode by pressing the HOME and ENTER
buttons simultaneously for three seconds.
2. Press the MACRO button next to the LCD screen.
3. Important: Press the PAGE button.
4. Press one of the 10 device buttons.
5. Press the functional buttons you wish to store in the device
macro button you selected in the order you want them stored.
Up to 20 commands can be stored.
Note:
Do not press the HOME button at the beginning of a
macro, or it will not work. The HOME button can be
used at any other step in a macro.
6. Be sure to end your macro on the Device page that you would
like to remain on when the macro is sent in normal use.
7. Return to step 4 until all desired commands are programmed.
8. Save the commands selected to the macro button by pressing
the CH UP button.
9. Once you complete the programming and wish to exit from
this mode, press the HOME button. Exit from the SET UP mode
by pressing the HOME button once again. Tip: Remember that
a single push of a Device Button that has a macro connected
to it will take you to that device's function pages. Hold the
Device Button down for one second in order to send the macro
that you have created for that Device Button.
Note:
Pressing the PAUSE button (bottom right of cursor
pad) during the macro programming will add a time
delay of 0.2 seconds between the commands. For
example, pressing the PAUSE button three times will
create a pause of 0.6 seconds between the com-
mands where the delay was inserted. Pressing PAUSE
does not count as a macro step.
When using a macro, remember to keep the remote pointed
toward the components until the macro is finished being transmit-
Lexicon
C-11