Lexicon RV-8 User Manual page 204

Appendix C
one device at a time, press the DEVICE button.
5. Press the DEVICE button to show all of the devices. Press the
device button you wish to clone.
6. Set the RV-8 remote head-to-head with another RV-8 remote.
Each unit should be in either cloning from or cloning to mode,
based on the above steps.
7. Press the START button on both units to begin cloning. It will
take about 40 seconds to complete the cloning. The LCD will
flash "GOOD" upon completion.
8. Exit from the Cloning mode by pressing the HOME button and
then exit from the SETUP mode by pressing the HOME button
again.
Adjusting the LCD contrast
To adjust the LCD contrast:
Pressing the HOME button and Up on the joystick simultaneously
will make the LCD contrast darker. Pressing the HOME button and
Down on the joystick simultaneously will make the LCD contrast
brighter.
Battery Life
Under normal operating conditions, the batteries will last approxi-
mately six months. If the batteries are running low, there will be
reduced range from the remote, commands that are not sent prop-
erly, or are not sent at all. The backlighting of the LCD screen and
the buttons may be diminished. Should any of these occur, replace
the batteries immediately. To ensure proper performance of the
remote, use four new AAA alkaline batteries. However, the worn
batteries should be replaced with a fresh set as soon as possible. Do
not mix new and used batteries.
Note:
• If the batteries are running low, the LCD displays
"LOW BATTERY" when the POWER button is
pressed, or when the HOME and ENT buttons are
pressed simultaneously.
• The remote has an internal memory lock system
that retains all of the programs and learned
functions for an extended period of time in the
event of battery loss or replacement.
The LCD screen is breakable glass. Do not tap the LCD screen
CAUTION
to activate devices. Use the rubber buttons beside the labels
on the screen.
The RV-8 remote control is not waterproof. Never immerse it in
water. Keep the LCD screen dry. Immediately wipe off any
spilled liquid.
Do not expose the RV-8 remote to extreme temperatures.
Keep it away from any heat sources.
Avoid dropping the remote control.
Clean the LCD screen with a soft cloth. Never use abrasives or
cleaning solutions on the soft cloth.
Lexicon
C-17