Setting The [Pumps]; Setting Up [Pump 1] - ProMinent DULCOMETER Assembly And Operating Instructions Manual

Setting the [Pumps]

12 Setting the [Pumps]
User qualification: trained user, see
n
Ä Chapter 4.4 'Users' qualifications'
on page 21
Continuous display ➨
[Pumps] ➨ [Pumps]
Settings for [Channel 2]
In its 2-channel version, the controller
has two measurement channels. This
description for [Channel 1] applies
correspondingly for the settings in
[Channel 2]. The procedure for
making the settings for the channel in
question is identical, however the
parameters to be set may be different.
Differences are pointed out and are
also described.
Pumps
Pump 1 channel 1
Pump 2 channel 1
Pump 3 channel 2
Pump 4 channel 2
Fig. 89: Setting the [Pumps]
Set-up of [Pump 1] or [Pump 2]
Solely the process for[ Pump 1] is
described. The set-up process for
[Pump 2], [Pump 3] or [Pump 4] is the
same as for [Pump 1].
120
➨ or
A1064
12.1

Setting up [Pump 1]

WARNING!
Priming with
Cause: If you select the function
[Priming with <OK>] when the pumps
are connected and operable, the
pumps continue to operate at 100 %
power for as long as you press the
key. This function is used to bleed the
pump and the feed and drainage
lines.
Possible consequence: Death or
serious injury may result from the
uncontrolled transport of feed chem‐
ical.
Measure:
– Ensure that the function
[Priming with <OK>] cannot result
in the unregulated escaping of
feed chemical.
– Ensure that the function
[Priming with <OK>] cannot
supply any process in an unregu‐
lated manner with feed chemical.
– Refer to the safety data sheets on
your feed chemicals.