Setting Measurement Conditions
Adjusting the Optical Axis and Registering
the Standard Received Light Intensity
When using an integrated Sensor, adjustment of the optical axis in step 3 is not required.
Important
Connect the Controller and Sensor sync wires.
• Wiring the Sensor (emitter) p.29
• Wiring the Controller p.30
1
Switch to the optical axis adjustment mode.
2
Switch to the received light balance display to
show
received
intensity.
3
Adjust the emitter while verifying the light intensity.
• Adjusting the received light intensity while
viewing the receiver
Move the emitter in the four directions (left, right,
top and bottom) to adjust the received light
intensity until the optical axis setting indicator
(green) on the receiver lights.
42
Setting Measurement Conditions - FUN Mode
Select [ALIGN].
light
balance
Confirm the selection.
SUB
and
light
SUB
Emitter
- FUN Mode
Receiver
Optical axis
setting indicator
ZX-GT User's Manual