Table of Contents
Advertisement
5-3-2
Setting Slave Input Data in Idle State
Set to hold or clear the last data for an input assembly that the NE1A-SCPU01 transmits to the Standard
Master in either of the following conditions:
•
When changing the NE1A-SCPU01 from the RUN state to the IDLE state.
•
When detecting an error, such as a communications error in a safety chain, that sets the data to an I/O
tag in an input assembly.
5-3-3
Setting Assembly Data
This section describes how to define I/O assembly data.
I/O Type
Select the connection type to use for the I/O assembly. Input assemblies and output assemblies can be reg-
istered for each connection. Output assembles cannot be registered, however, when Bit-Strobe is selected
as the connection type, because the data cannot be output by the Standard Master.
I/O Tag
Multiple I/O tags can be defined in an I/O assembly. The I/O tags defined here can be used in the Logic Ed-
itor.
•
Click the New Button and set a tag name and data type when defining a new I/O tag. I/O tags for up to
16 bytes can be defined in each I/O assembly.
•
To change an I/O tag that has already been defined, select the I/O tag you want to change and click the
Edit I/O Tag Button.
•
To delete an I/O tag that has already been defined, select the I/O tag you want to delete and click the
Delete Button.
88
Section 5: Editing Safety Network Controller Parameters
Advertisement
Table of Contents
Need help?
Do you have a question about the DEVICENET SAFETY - CONFIGURATION MANUAL 05-2005 and is the answer not in the manual?
Questions and answers