Deleting Devices - Omron DEVICENET SAFETY - CONFIGURATION MANUAL 05-2005 System Configuration Manual

(3) Right-click without selecting any device in the Network Configuration Pane and select Upload.
If there is another device that must be added after the upload has completed, add the device following the
same procedure as in Adding Devices from the Hardware List, above.
IMPORTANT:
Note: – When a network is uploaded, the virtual network information that was displayed until then will be
deleted. If the previous virtual network information is required, save the data before the network up-
load.
– When a network in which devices already have a set network number is uploaded, the value that is
already set in the devices is used for the network number.
2-4-4

Deleting Devices

There are three ways to delete a device from a virtual network.
(1) Select a device, and then select Edit - Delete from the menu bar.
(2) Select a device, and then click the Delete Button on the toolbar.
(3) Select a device, and then right-click the selected device and select Delete.
A confirmation dialog box will be displayed before the deletion. Click the Delete Button to delete the device.
36
When the CS/CJ-series DeviceNet Unit exists in the network, disable the master function-
ality of the CS/CJ-series DeviceNet Unit, and then do the upload. If the master functionality
is enabled, uploading the device parameters may fail.
Section 2: Basic Operation of the Network Configurator