Table of Contents
Advertisement
B
Editing CS/CJ-series DeviceNet Unit Parameters
This section describes how to edit the parameters of a CS/CJ-series DeviceNet Unit.
B-1
Setting the Unit Functions
The master function and slave function can be set.
Follow the procedure below to perform the settings.
1.
Select the icon of the master in the Network Configuration Pane (right pane).
2.
Select Device - Property.
The following window will be displayed. Click the Unit Function Tab.
3.
Select the Enable Master Function or Enable Slave Function Option (or both).
B-2
Master Parameter Overview
Use the following procedure to open the Parameter Edit Window.
1.
Select the device for which you want to edit the parameters.
2.
Select Device - Parameter - Edit.
3.
The Edit Device Parameters Window for the master will be displayed.
Note: – If the I/O size of the device displayed in the Network Configuration Pane and the I/O data size of
the device registered in the Scan List do not match, the following warning dialog box will be dis-
played and the I/O size set in the Scan List will be given priority.
If there is a slave with no EDS installed, obtain an EDS and install it.
– If a slave device registered to another master device is registered in the Scan List, the following
warning message will be displayed when the Edit Device Parameters Window is displayed.
Modify the registered slave in the Scan List.
B-1 Setting the Unit Functions
143
Advertisement
Table of Contents
