Adding Devices - Omron DEVICENET SAFETY - CONFIGURATION MANUAL 05-2005 System Configuration Manual

If the network number is not set correctly, a connection may be opened to a different device. A different net-
work number must be set for each network domain, and the same network number must be set for all the
devices on the same domain.
2-4-3

Adding Devices

There are two ways to add a device to the virtual network.
(1) Adding from the Hardware List.
(2) Uploading the network configuration from the actual network.
Adding Devices from the Hardware List
There are two ways to add a device to the virtual network from the Hardware List.
(1) Double-click the selected device in the Hardware List.
(2) Select the device from the Hardware List and drag it to the Network Configuration Pane.
When a device has been registered, it will be displayed as follows:
Uploading the Network Configuration from the Actual Network (Network Upload)
The network configuration can be read from the actual network and to create the same configuration in the
virtual network. Connect the Network Configurator to the network, and then upload the network configuration
using any of the following methods.
(1) Select Network - Upload from the menu bar.
(2) Click Upload from Network on the toolbar. Uploading will start, and the detected devices will be dis-
played sequentially.
2-4 Creating a Virtual Network 35