Table of Contents
Advertisement
Send Message
•
Target Node
Set in hexadecimal the destination node address to which to send the explicit message.
•
Service Code
Set the service code of the explicit message in hexadecimal.
•
Class ID
Set the class ID of the explicit message in hexadecimal.
•
Instance ID
Set the instance ID of the explicit message in hexadecimal.
•
Service Data
Set any service data in hexadecimal.
6-3-3
Saving the Program
Use the following procedure to save the program.
1.
Select File - Apply.
The program is saved temporarily in the Network Configurator. The data is also saved temporarily in the
same way when the user exits the Logic Editor.
2.
After exiting the Logic Editor, click the OK Button in the Edit Device Parameters Dialog Box.
3.
To save the file, select File and Save or Save As in the Main Window of the Network Configurator.
IMPORTANT: • To save the program and exit, the user must click the OK Button in the Edit Device Param-
6-3-4
Updating the Program
If the I/O tags of the Safety Slaves that configure the NE1A-SCPU01 local I/O and connections are changed
(e.g., by adding or deleting I/O tags), the user must start the Logic Editor and check the program.
If the user downloads the parameters to the NE1A-SCPU01 without starting the Logic Editor, a download
error will occur in the Logic Editor because of data inconsistency. If this error occurs, start the Logic Editor
and check the program, making any required modifications.
108
eters Dialog Box when exiting the Logic Editor.
• If the user clicks the Cancel Button, none of the parameters entered until then, including
the program, will be saved. Any programming saved temporarily by selecting File - Apply
will also be deleted.
Section 6: Programming the Safety Network Controller
Advertisement
Table of Contents
