Omron DEVICENET SAFETY - CONFIGURATION MANUAL 05-2005 System Configuration Manual page 106

Jump Addresses
The Jump Address menu commands can be used when the program is complex or when it spans multiple
pages.
1. First, set the source jump address using either of the following methods:
(1) Select Function - Jump Address - New from the menu bar.
(2) Right-click in the Workspace and select Jump Address.
2. Enter a name for the jump address and click the OK Button.
The jump address will be displayed as follows:
3. Enter the jump destination using either of the following methods:
(1) Select Menu - Jump Address - Select from the menu bar.
(2) Right-click in the Workspace and select Select Jump Address.
104 Section 6: Programming the Safety Network Controller