Table of Contents
Advertisement
2-10-4
Changing Device Status
Changing the device status is not supported by all devices.
The NE1A-SCPU01 can switch between IDLE mode and RUN mode. For details on NE1A-SCPU01 modes,
refer to the Safety Network Controller Operation Manual (Z906).
For DST1-series Safety I/O Terminals, there is no need to change modes.
Change the device mode using either of the following methods. This function is enabled only when the Net-
work Configurator is online.
(1) Select a device, and then select Device - Change Mode followed by the desired mode.
(2) Select a device, and then right-click the device and select Change Mode followed by the desired mode.
Next, the password input window for the device will be displayed. Enter the password for the selected devices
and click the OK Button.
2-10 Device Reset and Status Change
51
Advertisement
Table of Contents
Need help?
Do you have a question about the DEVICENET SAFETY - CONFIGURATION MANUAL 05-2005 and is the answer not in the manual?
Questions and answers