Replacing Parts; Instructions And Warnings For The Replacement Of Parts; Replacement Of The Burner Nozzle - Angelo Po 1N1BR2G User Manual

ITALIANO

INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS

NOTE: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during instal-
lation and commissioning, adjustments and
part replacement.
WARNING: Before making any type
of adjustment, activate all the safety devic-
es provided and decide whether staff at work
and those in the vicinity should be informed.
In particular, close the the gas and water sup-
ply taps, cut off the electricity supply using
the master switch and prevent access to all
devices which might cause unexpected haz-
ards and damage to people's health and safe-
ty if activated.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Remove the knob (C).
2)
Undo the screws (A) and remove the control
3)
panel (B).
C
A
18

REPLACING PARTS

REPLACEMENT OF THE BURNER NOZZLE

B
A
Also make sure that during the maintenance
procedure, that the operator is always able to
check whether the plug is disconnected from
the power outlet.
If worn parts have to be replaced, use origi-
nal spare parts only. The manufacturer de-
clines all responsibly for injury or damage to
components due to the use of non original
parts, or extraordinary work on the applian-
ce which may modify the safety requirements
without the manufacturer's authorisation.
When ordering components, follow the in-
structions provided in the parts catalogue.
Unscrew the nozzle (D) and replace it with
4)
the one suitable for the type of gas in use
(see table at back of manual).
Replace the control panel (B) and the knob
5)
(C)on completion of the operation.
REPLACING PARTS
D
3301311_inst_GB_rev.1