Table of Contents
Advertisement
To carry out this operation, proceed as follows.
1 - Fit the spanner (A) onto the hexagon (B).
2 - Keep a firm grip on the spanner (A) and undo the
locking screws (C).
3 - Turn the spanner (A) clockwise to load the spring
or anti-clockwise to release it.
4 - Once the correct balance is obtained, screw in the
screws (C) without tightening them fully.
5 - Use the spanner (A) to turn the shaft until it is lo-
cated in one of the seats provided.
6 - Fully tighten the screws (C).
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off the knobs
(A).
3 - Remove the knob
units (B).
4 - Undo the screws (C) and
remove the control pan-
el (D).
5 - Undo the screws (E) and
extract the cap (F).
6 - Pull off the cone (G).
7 - Clean the cone (G) and its seat.
8 - Coat the cone with grease (G), fit it in its seat and
AUS
turn it a few times.
9 - Pull off the cone (G) to remove the excess grease.
Before carrying out any replacement procedure, acti-
vate all the safety devices provided and decide
whether staff at work and those in the vicinity should
be informed. In particular, turn off the gas supply tap
and prevent access to all devices which might cause
unexpected health and safety hazards if turned on.
If work parts have to be replaced, use original spare
parts only.
ADJUSTING THE LID COUNTER-BALANCING
GREASING THE GAS TAP
B
REPLACING PARTS
RECOMMENDATIONS FOR REPLACING PARTS
C
B
C
D
A
10 - Replace the cone (G), the cap (F), the control pan-
el (D) and the knobs (A and B).
The manufacturer declines all responsibly for injury or
damage to components due to the use of non original
parts, or extraordinary work on the appliance which
may modify the safety requirements without the man-
ufacturer's authorisation.
When ordering components, follow the instructions
provided in the parts catalogue.
- 16 -
A
IDM-39603304700.tif
F
G
E
IDM-3960330060.tif
9
Advertisement
Table of Contents
