Table of Contents
Advertisement
Before carrying out any replacement procedure, acti-
vate all the safety devices provided and decide
whether staff at work and those in the vicinity should
be informed. In particular, turn off the gas supply tap
and prevent access to all devices which might cause
unexpected health and safety hazards if turned on.
If work parts have to be replaced, use original spare
parts only.
To carry out this operation, proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off knob (A) and
disassemble handle
(B).
3 - Undo the screws (C)
and remove panel
(D).
4 - Unscrew the nozzle
(E) and replace it with the
one suitable for the type of
gas in use (see table at
IT
back of manual).
AUS
5 - Return the appliance to its initial configuration
when the operation is complete.
DE
FR
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply tap.
ES
2 - Pull off knob (A) and dis-
assemble handle (B).
3 - Undo the screws (C) and
remove panel (D).
4 - Slacken the screw (E).
5 - Extract the bushing (F)
and replace it with the one
suitable for the type of gas
in use (see table at back of
manual).The
should be adjusted to its maximum opening
(24mm between Injector and face of Bushing)
REPLACING PARTS
RECOMMENDATIONS FOR REPLACING PARTS
REPLACEMENT OF THE BURNER NOZZLE
B
REPLACING THE PRIMARY AIR BUSHING
B
Bushing
The manufacturer declines all responsibly for injury or
damage to components due to the use of non original
parts, or extraordinary work on the appliance which
may modify the safety requirements without the man-
ufacturer's authorisation.
When ordering components, follow the instructions
provided in the parts catalogue.
A
C D C
A
C D C
6 - Return the appliance to its initial configuration when
the operation is complete.
- 16 -
9
E
IDM-39604005800.tif
E
F
IDM-39604005900.tif
Advertisement
Table of Contents
