Table of Contents
Advertisement
20. Pull platform (A) toward the cab until it stops and the latch
is engaged.
21. If this is the first time the header is connected to the
windrower, calibrate the header. For instructions, refer to
5.3 Calibrating Header on HarvestTouch
5.1.4 Detaching D2 Series Draper Header
The instructions in this section outline how to properly detach the header from the windrower.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1. Start the engine.
2. Press HEADER UP button (A) on the ground speed lever
(GSL) to raise the header to maximum height.
3. If one end of the header does NOT rise fully, rephase the
cylinders as follows:
a.
Press and hold HEADER UP (A) switch until both
cylinders stop moving.
b. Continue to hold the switch for 3–4 seconds. The
cylinders are now phased.
4. Shut down the engine, and remove the key from
the ignition.
262177
ATTACHING HEADERS TO WINDROWER
™
Display, page
225.
197
Figure 5.27: Left Platform
A
Figure 5.28: Ground Speed Lever (GSL)
A
Revision A
Advertisement
Table of Contents
