Table of Contents
Advertisement
3. Check engine speed (A) on the HarvestTouch
Compare the current engine speed to the value in the
table below.
4. Move the throttle to its highest possible setting.
5. Check engine speed (A) on the HarvestTouch
Compare the current engine speed to the value in Table
4.2, page
159.
NOTE:
The engine speed specifications in the table below are
provided on the assumption that the windrower's Eco
Engine Control (EEC) feature is NOT ACTIVE. For more
information about EEC, refer to the windrower operator's
manual.
Table 4.2 Engine Speed
1000 rpm
6. Shut down the engine, and remove the key from the ignition.
4.2.9 Checking Retract and Extend Functions of the Narrow Transport System
The narrow transport feature needs to be checked if the drive wheel legs and walking beam extensions fully extend and
retract.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
1. Ensure that the narrow transport function is enabled on the HarvestTouch
Setting Wheel Drive Options – Narrow Transport, Tire Size, and Wheel Type, page
2. Shut down the engine, and remove the key from the ignition.
3. Retrieve the transport harness from holder (A), located
behind the left platform, and connect it to electrical
receptacle (B).
262177
PERFORMING PREDELIVERY CHECKS
™
Display.
™
Display.
Idle
Figure 4.79: HarvestTouch
Maximum (No Load)
™
Display. For instructions, refer to
B
A
Figure 4.80: Transport Electrical Connector
159
A
™
Display
2300 rpm
157.
4.2.7
Revision A
Advertisement
Table of Contents
