Table of Contents
Advertisement
4.1.6 Checking Fuel Separator
The fuel separator removes water and sediment from the fuel to prevent damage to the engine. It will need to be
inspected to ensure that it is clean.
1. Place a container under filter drain valve (A).
2. Turn drain valve (A) by hand 1 1/2 to 2 turns
counterclockwise until fuel begins draining.
3. Drain the filter sump of water and sediment until clear fuel
is visible. Clean the sump as needed.
4. Turn drain valve (A) by hand 1 1/2 to 2 turns clockwise until
it is tight.
5. Dispose of the fuel in a safe manner.
4.1.7 Checking And Adding Engine Coolant
Coolant is cycled through the engine to help reduce internal heat. The coolant must be at the appropriate level for the
cooling system to work correctly.
Checking engine coolant level
1. Locate coolant recovery tank (A).
2. Visually inspect the coolant level. Ensure that the coolant
level is at MAX COLD line (B). If the coolant level is too low,
add coolant.
NOTE:
For the coolant specifications, refer to the inside
back cover.
262177
PERFORMING PREDELIVERY CHECKS
Figure 4.13: Fuel Filter
Figure 4.14: Coolant Recovery Tank
128
A
A
B
Revision A
Advertisement
Table of Contents
