Table of Contents
Advertisement
5.2.3 Connecting Header Hydraulic and Electrical Systems
The header's hydraulic hose multicoupler will need to be connected to the windrower.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
CAUTION
Do NOT stand on an unlocked platform. It is unstable and may cause you to fall.
IMPORTANT:
To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all hydraulic couplers.
1. Shut down the engine, and remove the key from the ignition.
2. Approach platform (A) on the left side of the windrower.
Ensure that the cab door is closed.
3. Push latch (B) and pull platform (A) toward the walking
beam until it stops and the latch engages.
4. Push lever (A) up and pull arm (B) to get pin (C) out of
latch (D).
262177
ATTACHING HEADERS TO WINDROWER
214
A
Figure 5.64: Left Platform
D
A
Figure 5.65: Hydraulic Hose Management System
B
1015479
B
C
Revision A
Advertisement
Table of Contents
