Table of Contents
Advertisement
3.9 Connecting Wheel Leg Hydraulics and Electrical System
Reconnect the wheel leg hydraulic and electrical connections that were disconnected for shipping purposes.
NOTE:
A bag containing 14 medium cable ties (MD #21763) and one large cable tie (MD #30753) is shipped inside the windrower
cab. This procedure requires medium cable ties.
Junction manifold hydraulic connections
1. Connect the hoses from the left wheel leg to the junction
manifold as follows:
a.
Connect 3/8 in. internal diameter (ID) lift hose (A)
without a cable tie to port HL.
b. Connect 1/4 in. ID float hose (B) marked with a yellow
cable tie to port FL.
c.
Connect 3/8 in. ID lift hose (C) marked with a yellow
cable tie to port CL.
d. Connect 1/2 in. ID case drain hose (D) marked with a
red cable tie to port MDL.
2. Connect the hoses from the right wheel leg to the junction
manifold as follows:
a.
Connect 1/2 in. ID lift hose (A) without a cable tie to
port HR.
b. Connect 1/4 in. ID float hose (B) marked with a black
cable tie to port FR.
c.
Connect 3/8 in. ID lift hose (C) marked with a black
cable tie to port CR.
d. Connect 1/2 in. ID case drain hose (D) marked with a
blue cable tie to port MDR.
262177
ASSEMBLING WINDROWER
Figure 3.51: Junction Manifold Left Leg Hoses
Figure 3.52: Junction Manifold Right Leg Hoses
65
A
B
C
D
A
B
C
D
Revision A
Advertisement
Table of Contents
