Table of Contents
Advertisement
1. Park the windrower on level ground.
2. Rotate the wheel drive until fill/drain plug (A) is at the
12 o'clock position and check plug (B) is at the 3 o'clock
position as shown.
3. Shut down the engine, and remove the key from
the ignition.
WARNING
Use caution when removing the plug, as the fluid may still be
under pressure.
4. Remove check plug (B). The lubricant should be visible
through the port. Some lubricant may leak from the port.
5. Reinstall check plug (B). Torque the plug to 7.5 Nm
(6 lbf·ft [72 lbf·in]).
6. If removed, reinstall fill/drain plug (A). Torque the plug to
24 Nm (18 lbf·ft [216 lbf·in]).
4.1.14 Checking Tire Pressure
The windrower's drive and caster tires must be inflated to the proper pressure level.
Caster wheel tires: Inflate all caster wheel tires (B) to
110 kPa (16 psi).
Drive wheel tires: The maximum inflation pressure for drive
tires (A) is 241 kPa (35 psi).
262177
PERFORMING PREDELIVERY CHECKS
Figure 4.48: Wheel Drive – 12 Bolt
Figure 4.49: Windrower Tires
146
A
A
B
B
Revision A
Advertisement
Table of Contents
