Connecting Header Hydraulic And Electrical Systems To M2 Series Windrower - MacDon M2170NT Unloading And Assembly Instructions

5.1.3 Connecting Header Hydraulic and Electrical Systems to M2 Series Windrower

The header's hydraulic hose multicoupler will need to be connected to the windrower.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
CAUTION
Do NOT stand on an unlocked platform. It is unstable and may cause you to fall.
IMPORTANT:
To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all (fixed and
movable) hydraulic couplers.
1. Shut down the engine, and remove the key from the ignition.
2. Approach platform (A) on the left side of the windrower.
Ensure that the cab door is closed.
3. Push latch (B) and pull platform (A) toward the walking
beam until it stops and the latch engages.
4. Push the link on latch (C) and pull handle (A) on hydraulic
hose management system (B) rearward to disengage the
arm from the latch.
5. Move hydraulic hose management system (B) toward the
left cab-forward side of the windrower.
262177
ATTACHING HEADERS TO WINDROWER
194
A
Figure 5.19: Left Platform
C
Figure 5.20: Hydraulic Hose Management System
B
1015479
B
A
Revision A