Table of Contents
Advertisement
3.21 Lubrication
Proper lubrication is essential to ensuring the service life of the windrower.
For information on the type of lubricants to use, refer to the inside back cover of this book for quick reference.
3.21.1 Greasing Procedure
Add grease to these fittings before delivering the windrower. Be sure to leave a small amount of grease on top of each
fitting to prevent contamination.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
1. To avoid injecting dirt and grit, wipe each grease fitting with a clean cloth before greasing.
2. Inject grease through the fitting with a grease gun until the grease overflows the fitting, except where noted. For
specifications, refer to the inside back cover.
3. Leave excess grease on the fitting to keep out dirt.
4. Replace any loose or broken fittings immediately.
5. If a fitting will NOT take grease, remove and clean it thoroughly. Also clean the grease passageway. Replace the fitting
if necessary.
3.21.2 Grease Points
Add grease to these fittings before delivering the windrower. Be sure to leave a small amount of grease on top of each
fitting to prevent contamination.
262177
ASSEMBLING WINDROWER
A
115
B
C
Revision A
Advertisement
Table of Contents
