3.16 Installing Air Inlet Duct
The air inlet duct prevents large debris from entering the engine.
1. Retrieve air inlet duct (A) from inside the cab. The inlet duct
consists of:
• Cap (A)
• Clamp (B)
• Setscrew (C)
2. Ensure that there are no parts or debris inside the
inlet duct.
3. Remove the plastic cover from the breather tube.
4. At the rear right corner of the cab roof, set air inlet duct (A)
over the breather tube, and rotate it to align the predrilled
holes for setscrew (B).
5. Tighten setscrew (B).
6. Ensure that there is 0–4 mm (0–5/32 in.) of space (C)
between setscrew (B) and clamp (D).
7. Ensure that there is 5 mm (13/64 in.) of space (E) between
the clamp and the bottom of the duct.
8. Tighten clamp (D) to 6.2 Nm (5 lbf·ft [55 lbf·in]).
262177
ASSEMBLING WINDROWER
Figure 3.108: Air Inlet Duct
A
C
Figure 3.109: Air Inlet Duct
99
B A
A C
B
D
B
E
Revision A