Attaching Headers; Attaching A D-Series Header; Attaching Header Boots - MacDon M155E4 2016 Manual

3.10 Attaching Headers

3.10.1 Attaching a D-Series Header

D50, D60, and D65 headers can be attached to an M155E4 Self-Propelled Windrower.
The M155E4 Self-Propelled Windrower is factory-equipped
to run a D-Series Draper Header.
If installing an HC10 Hay Conditioner, reverser kit
MD #B4656 is recommended. If necessary, obtain the
recommended kit and install it in accordance with the
instructions supplied with the kit.
Refer to the following instructions based on the type of
center-link installed on your windrower:
• Attaching a D-Series Header: Hydraulic Center-Link
with Optional Self-Alignment, page 27
• Attaching a D-Series Header: Hydraulic Center-Link
without Self-Alignment, page 32

Attaching Header Boots

Header boots are required to attach a D-Series draper header to the windrower. Attach header boots (supplied
with header) to windrower lift linkage if not already installed.
CAUTION
To prevent damage to the lift system when lowering
header lift linkages without a header or weight
box attached to the windrower, ensure the float
engagement pin is installed in storage position (B)
and NOT in engaged position (A).
147764
ASSEMBLING THE WINDROWER
Figure 3.34: M155E4 Draper Header Hydraulics
Figure 3.35: Header Float Linkage
26
Revision A