Table of Contents
Advertisement
3.7 Installing Caster Wheels
Caster wheels are non-driven wheels mounted at the end of the windrower near the engine.
1. Remove two bolts and nuts (A), and two rear wearplates (B)
from the center support.
NOTE:
The hardware bag for mounting the rear wearplates to the
walking beam is secured to the rear wearplates, which are
not shown in the illustration.
2. Position rear wearplate (A) inside wearplate mount (B) of
walking beam (C) with the grease groove facing away from
the wearplate mount. Secure the wearplate with bolts (D),
and torque the bolts to 43 Nm (32 lbf·ft).
NOTE:
Wearplate mount (B) is transparent in the illustration so the
rear wearplate is visible.
3. Loosely install bolt with zerk (E) into the inboard hole. Do
NOT torque the bolt until the p-clip is installed when
installing the hydraulics.
4. Repeat Step
2, page 56
opposite side.
5. Keep the left and right shimmy shock mounts (B) and caster
wheel extensions (C) separate for reinstallation.
6. Remove bolts and nuts (A) and shimmy shock mounts (B)
from the shipping stand. Retain the parts for
installation later.
262177
ASSEMBLING WINDROWER
to Step
3, page 56
at the
Figure 3.25: Caster Wheels Shipping Assembly
A
Figure 3.26: Rear Wearplate in Walking Beam — Left
Side Shown
A
B
C
Figure 3.27: Anti-Shimmy Dampener Bracket
56
A
B
C
B
D
E
A
C
Revision A
B
Advertisement
Table of Contents
