Table of Contents
Advertisement
3.20 Installing Rear Light Assembly and Optional Ballast Package
Ballast kits are for draper headers only. When operating the windrower with a heavy draper header, ballast needs to be
added to the aft end. Use the following table to determine the amount of ballast required. Depending on the ballast
requirements, follow the instructions to install rear light assembly with or without the optional ballast package.
Refer to
4.1.14 Checking Tire Pressure, page 146
NOTE:
A base kit (MD #B6053) contains eight 20.4 kg (45 lb.) weights for a total weight of 163 kg (360 lb.).
Table 3.4 Ballast
Header Type
7.6 m (25 ft.) single reel,
D125X
double knife, timed
9.1 m (30 ft.) single reel,
D130XL
double knife, timed
9.1 m (30 ft.) single reel,
D130XL
double knife, timed
10.7 m (35 ft.) single reel,
D135XL
double knife, untimed
10.7 m (35 ft.) single reel,
D135XL
double knife, untimed
10.7 m (35 ft.) single reel,
D135XL
double knife, untimed
10.7 m (35 ft.) double reel,
D135XL
double knife, untimed
10.7 m (35 ft.) double reel,
D135XL
double knife, untimed
10.7 m (35 ft.) double reel,
D135XL
double knife, untimed
Installing rear light assembly – no ballast package required
1. Remove eight bolts and washers (A) from the rear light
assembly, and remove bezel (B).
262177
ASSEMBLING WINDROWER
for proper tire pressures when operating with the applicable header.
Description
Transport + upper cross
auger + vertical knives
Transport + upper cross
auger + vertical knives
Transport + upper cross
auger + vertical knives
Installed Options
Base Kit
–
Transport
Base
Transport
Base
Transport
A
Figure 3.129: Rear Light Bezel Assembly
110
Additional
Float Springs
Kits
0
0
1
0
1
0
1
0
1
0
1
0
1
0
1
0
1
0
A
B
A
Additional
0
0
MD #B6047
0
MD #B6047
MD #B6047
0
MD #B6047
MD #B6047
A
Revision A
Advertisement
Table of Contents
