Safety; To Raise & Lower Deck; Side Delivery Draper Speed - MacDon M150 2009 Setup Instruction

CAUTION: To avoid bodily injury:
1. Review the safety sections of your
tractor and header Operator's Manuals.
2. Keep all shields in place.
3. Engage safety pin (A) when deck is
raised fully for transport, service and
storage or before going under deck for
any reason. To engage safety pin, raise
deck, rotate pin and push in until both
roll pins (B) are inside channel.
4. Keep away from moving draper and
rollers.
5. Keep clear of the deck while it is being
raised or lowered.
To raise and lower deck:
Extra caution should be taken when
NOTE:
raising the deck for the first time.
rotates as it raises and lowers and the
backsheet folds on to the deck. Make sure the
deck and backsheet are not interfering with any
tractor parts or the forming shield.
In the setup instructions, if you chose to swap
the DWA controls, use the reel fore/aft switch to
raise and lower the deck.
forward when lowering, so switch operation will
be the same as when moving the reel forward.
The deck moves rearward when raising so
switch operation will be the same as when
moving the reel rearward.
In the setup instructions, if you chose "NO" to
swap the DWA controls, use the rocker switch
installed in the console. Press the rocker switch
forward portion to lower the DWA and press the
rocker switch rearward portion to raise the DWA.
NOTE: Draper shuts off automatically when
deck is raised about two thirds of the way up. If
deck does not shut off soon enough, resulting in
backsheet touching draper before it shuts off,
the switch at the linkage needs to be lowered.
Lower switch by loosening two screws (C). Do
not over tighten the screws or the switch will not
work.

Side delivery draper speed:

To set the draper speed, turn the draper speed
control.
Form 169216
OPERATION
The deck
The deck moves
15
B
A
SAFETY PIN
DWA DOWN
DRAPER SPEED
DWA DOWN
DECK LIFT CONTROLS
DRAPER SHUT-OFF SWITCH
DWA UP
C
January 2009