Lubricating The Windrower; Procedure; Lubrication Points - MacDon M150 Operator's Manual

7.6

LUBRICATING THE WINDROWER

WARNING
To avoid personal injury, before servicing
windrower or opening drive covers, follow
procedures in Section 7.1 PREPARATION
FOR SERVICING.
Recommended Lubricant
LUBRICANT SPEC
SAE
Grease
Multi-
Purpose
The greasing points are marked on the machine
by decals showing a grease gun and grease
interval in hours of operation. See illustration
below.
Log hours of operation and use the "Maintenance
Checklist" provided to keep a record of scheduled
maintenance.
MAINTENANCE SCHEDULE.
7.6.1

PROCEDURE

DANGER
Stop engine and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
Form 169017 / 169087 / 169095
MAINTENANCE AND SERVICING
DESCRIPTION USE
High Temp. Extreme
Pressure (EP2)
As Required
Performance With 1%
Unless
Max Molybdenum
Otherwise
Disulphide
Specified
(NLGI Grade 2)
Lithium Base
Refer to Section

7.6.2 LUBRICATION POINTS

Refer to the illustrations on the following page to
identify the various locations that require
lubrication.
7.14
124
Revision C