Lubricating The Windrower; Lubrication Procedure - MacDon M155E4 2016 Manual

3.11 Lubricating the Windrower

Table 3.3 Recommended Lubricant
Specification
SAE Multi-Purpose

3.11.1 Lubrication Procedure

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
1. Wipe grease fitting with a clean cloth before greasing to avoid injecting dirt and grit.
2. Inject grease through fitting with grease gun until grease overflows fitting (except where noted).
3. Leave excess grease on fitting to keep out dirt.
4. Replace any loose or broken fittings immediately.
5. Remove and thoroughly clean any fitting that will not take grease. Also clean lubricant passageway. Replace
fitting if necessary.
147764
ASSEMBLING THE WINDROWER
Description
High temperature, extreme pressure (EP2)
performance with 1% max molybdenum disulphide
(NLGI Grade 2) lithium base.
61
Use
As required unless
otherwise specified.
Revision A