Lubricating The Windrower; Lubrication Procedure; Lubrication Points - MacDon M1170 Assembly Instructions Manual

3.12 Lubricating the Windrower

For grease specification, refer to

3.12.1 Lubrication Procedure

WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Wipe grease fitting with a clean cloth before greasing to avoid injecting dirt and grit.
2. Inject grease through fitting with grease gun until grease overflows fitting. Do NOT overgrease wheel bearings.
3. Leave excess grease on fitting to keep out dirt.
4. Replace any loose or broken fittings immediately.
5. Remove and thoroughly clean any fittings (including the lubricant passageway) that will not take grease.
Replace fitting, if necessary.

3.12.2 Lubrication Points

Figure 3.50: Lubrication Points
A - Top Link (Two Places) (Both Sides)
C - Forked Caster Wheel Bearing (Two Places) (Both Wheels)
214735
ASSEMBLING THE WINDROWER
5.1 Lubricants, Fluids, and System Capacities, page
A
B - Caster Pivot (Both Sides)
41
113.
B
C
Revision A