Chapter 3 First-time Use
3.2
Running a Self-test on the AVX-10K
NOTE:
A cable is required for the External Loopback test of the self-test. This cable is supplied
with the AVX-10K.
1.
Remove the protective film from the touchscreen.
2.
Power on the test set, and then perform the self-test:
3.3
Powering Off the AVX-10K
• Press the Power button, and then release it when with the VIAVI logo appears on
the touchscreen.
The AVX-10K performs a series of power-down processes and then powers off.
Page 3 - 2
i
On the Home screen, open the Self-Test ribbon, and then start the Self-Test
application.
ii
Select RUN, and follow the prompts as directed.
iii
When the Self-Test has completed running all tests, verify that each test has
passed. If any test fails, contact your VIAVI Customer Service
representative.
AVX-10K Getting Started Guide
22135253 Rev. 003