HP ProLiant DL560 Gen11 User Manual page 52

Remove the processor mezzanine tray Remove the processor mezzanine tray
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Press the buttons to rotate the processor mezzanine tray handle to the fully open position.
HPE ProLiant DL560 Gen11 Server User Guide 52