Advertisement
To align and seat the DIMM, use two fingers to hold the DIMM along the side edges.
To seat the DIMM, use two fingers to apply gentle pressure along the top of the DIMM.
For more information, see the Hewlett Packard Enterprise website (https://www.hpe.com/support/DIMM-20070214-CN
Installing a DIMM
Installing a DIMM
Prerequisites
Prerequisites
To meet the system thermal requirements, some DIMMs require specific processors and drive configuration. Review the product QuickSpecs
for these requirements on the HPE ProLiant DL560 Gen11 Server website:
https://buy.hpe.com/us/en/p/1014705735
https://buy.hpe.com/us/en/p/1014705735
About this task
About this task
CAUTION:
CAUTION:
Do not install ×4 and ×8 DRAM widths in the same server. All memory installed in the server must be of the same type.
Installing different DIMM types can cause the server to halt during BIOS initialization.
CAUTION:
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all DIMM slots have either a DIMM or a
DIMM blank installed.
CAUTION:
CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure
Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
6. Remove the access panel .
7. Do one of the following:
Remove the air baffle .
Remove the processor mezzanine tray .
8. Remove the DIMM blank.
https://www.hpe.com/support/DIMM-20070214-CN).
HPE ProLiant DL560 Gen11 Server User Guide
122
Advertisement
