HP ProLiant DL560 Gen11 User Manual page 14

Item Item Description Description
1 Primary riser slots 1–3 top to bottom
2 Secondary riser slots 4–6 top to bottom
3 Power supply 4 (PS4)
4 Power supply 3 (PS3)
5 Power supply 1 (PS1)
6 Power supply 2 (PS2)
7 VGA port
8 NS204i-u boot device (optional)
9 Slot 15 OCP
10 Serial port (optional)
11 iLO management port
12 USB 3.2 Gen 1 ports
13 Slot 14 OCP
When installing a single riser board, install it on the primary riser cage.
1
Subtopics Subtopics
Display device setup Display device setup
Display device setup Display device setup
This server supports both VGA port and DisplayPort 1.1a. Before connecting a display device to this server, review the information below.
Whenever possible, use the same display connection type. For example, if your PC or monitor only has a VGA output, connect it to the
server VGA port. Use of any kind of adapter or converter cable or dongle might lead to decreased display quality or a lag over the
connection.
DisplayPort connection: When connecting an HDMI or DVI display to the DisplayPort, use an active type adapter. Passive type adapter—
marked with the DP++ symbol—is not supported.
Display output modes:
If you connect two display devices to the VGA port and DisplayPort, the same image is shown on both devices—screen mirroring
mode.
The embedded video controller in the iLO 6 chipset does not support dual display or screen extension mode. To enable dual display
mode, install a compatible PCIe graphics card that supports this feature in the expansion slot.
1
HPE ProLiant DL560 Gen11 Server User Guide 14