Advertisement
Installing a transceiver
Installing a transceiver
Prerequisites
Prerequisites
Before installing a transceiver option, review the following:
Transceiver warnings and cautions
Transceiver documentation for specific operational and cabling requirements
Procedure
Procedure
1. Hold the transceiver by its sides and gently insert it into the network adapter port until it clicks into place.
Transceivers are keyed so that they can only be inserted in the correct orientation. If the transceiver does not fit easily into the port, you
might have positioned it incorrectly. Reverse the orientation of the transceiver and insert it again.
2. Remove the dust plug or protective cover from the transceiver.
3. Connect a compatible LAN segment cable to the transceiver.
4. Make sure that the NIC link LED on the port is solid green.
For more information on the port LED behavior, see the documentation that ships with the transceiver.
5. If needed, see the transceiver documentation for the model-specific fastening mechanism applicable to the transceiver.
Results
Results
The installation is complete.
Installing the System Insight Display module
Installing the System Insight Display module
Prerequisites
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm .
HPE ProLiant DL560 Gen11 Server User Guide
103
Advertisement
