HP ProLiant DL560 Gen11 User Manual page 165

T-10 Torx screwdriver
Phillips No. 1 screwdriver—This tool is required only if the M.2 SSDs are not preinstalled on the boot device carriers.
Procedure Procedure
Installing drives onto the boot device Installing drives onto the boot device
1. Remove the boot device carrier:
a. Press and hold the carrier latch (callout 1).
b. Pivot the latch to open (callouts 2).
c. Slide the carrier out from the boot device cage (callout 3).
2. Install the SSD on the boot device carrier:
a. Remove the SSD mounting screw.
b. Insert the SSD into the M.2 slot at a 45° angle (callout 1).
c. Carefully press the SSD down to the horizontal position (callout 2).
d. Install the SSD mounting screw (callout 3).
HPE ProLiant DL560 Gen11 Server User Guide 165