Advertisement
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Do one of the following:
Remove the air baffle .
Remove the processor mezzanine tray .
10. Remove the fan cage.
11. Disconnect the blank from the power switch/SID module connector.
The SID module cable will be connected to this same connector.
12. Remove the SID blank.
Retain the T-10 screw for later use.
13.
CAUTION:
CAUTION:
When routing cables, always be sure that the cables are not in a position where they can be pinched or crimped.
Route the SID cable through the opening in the front of the server, and then install the SID module.
Secure the module using the removed T-10 screw.
HPE ProLiant DL560 Gen11 Server User Guide
104
Advertisement
