HP ProLiant DL560 Gen11 User Manual page 109

Installing the optical drive in the universal media bay Installing the optical drive in the universal media bay
Installing the optical drive in the universal media bay Installing the optical drive in the universal media bay
Prerequisites Prerequisites
The optical drive installation requires the optical drive power cable (P55376-001) in the universal media bay option kit (P60500-B21).
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Do one of the following:
Remove the air baffle .
Remove the processor mezzanine tray .
10. Remove the fan cage.
11. Install the universal media bay in the server .
12. Install the optical drive bracket.
HPE ProLiant DL560 Gen11 Server User Guide 109