Advertisement
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the riser cage.
9. Remove the OCP slot blank:
a. Remove the blank screw (callout 1).
b. Use a plastic spudger to pry the top side of the blank from the chassis (callout 2).
c. Remove the blank (callout 3).
Retain the screw and blank for future use.
10. Install the type-o storage controller:
a. Rotate the locking pin to the open (vertical) position (callout 1).
b. Slide the controller into the bay until it clicks into place (callout 2).
Make sure that the controller is seated firmly in the slot.
c. Rotate the locking pin to the close (horizontal) position (callout 3).
HPE ProLiant DL560 Gen11 Server User Guide
127
Advertisement
