HP ProLiant DL560 Gen11 User Manual page 148

Results

The installation is complete.

Processor heatsink assembly option

Subtopics

Processor cautions

Installing the processor heatsink assembly

Processor cautions

CAUTION:

CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or

install the processor in this server.

CAUTION:

CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor configurations must

contain processors with the same part number.

CAUTION: The pins on the processor socket and on the processor are very fragile and easily damaged

CAUTION:

The pins on the processor socket and on the processor are very fragile and easily damaged . To avoid component

damage, do not touch these pins

do not touch these pins. Any damage to them might require replacing the system board and/or processor.

IMPORTANT: Processor socket 1 must be populated at all times or the server does not function.

IMPORTANT:

IMPORTANT: If installing a processor with a faster speed, update the system ROM before installing the processor. To

IMPORTANT:

download firmware, see Updating firmware or system ROM .

Installing the processor heatsink assembly

Prerequisites

Before you perform this procedure, make sure that you have the following items available:

T-30 Torx screwdriver

Processor option

About this task

This procedure only shows the installation steps for the standard and high performance heatsink options. In the liquid cooling configuration,

the liquid cooling options with the heatsinks are by default In the server.

Procedure

1. Power down the server.

2. If installed, open the cable management arm .

3. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

4. Disconnect all peripheral cables from the server.

HPE ProLiant DL560 Gen11 Server User Guide

148