Advertisement
booting up from flash solution
data backup/redundancy
Subtopics
Subtopics
Installing an internal USB device
Installing an internal USB device
Installing an internal USB device
Installing an internal USB device
Procedure
Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. If the expansion card is installed on the secondary riser cage, remove the secondary riser cage.
9. Plug in the USB device into the USB port.
10. If removed, install the secondary riser cage.
11. Install the access panel .
12. Installing the server into the rack .
13. Connect all peripheral cables to the server.
14. Connect each power cord to the power source.
15. Connect each power cord to the server.
16. Power up the server .
Results
Results
HPE ProLiant DL560 Gen11 Server User Guide
178
Advertisement
