Advertisement
Installing the universal media bay in the server
Installing the universal media bay in the server
6. If installed, remove the front bezel .
7. Power down the server.
8. If installed, open the cable management arm .
9. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
10. Disconnect all peripheral cables from the server.
11. Remove the server from the rack .
12. Place the server on a flat, level work surface.
13. Remove the access panel .
14. Do one of the following:
Remove the air baffle .
Remove the processor mezzanine tray .
15. Remove the fan cage.
16. Install the universal media bay in the server .
17. Cable the 2 SFF stacked drive cage:
Drive power cable
Storage controller cable
18. Connect the universal media bay cables to the system board .
19. Install the fan cage.
20. Do one of the following:
Install the air baffle .
HPE ProLiant DL560 Gen11 Server User Guide
119
Advertisement
