HP ProLiant DL560 Gen11 User Manual page 173

Installing the PDB Installing the PDB
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Install the PDB.
9. Install the power supplies 3 and 4 .
10. Install the access panel .
11. Installing the server into the rack .
12. Connect all peripheral cables to the server.
HPE ProLiant DL560 Gen11 Server User Guide 173