HP ProLiant DL560 Gen11 User Manual page 126

Preparing the server for storage controller installation

Prerequisites

Before beginning this procedure, download the Service Pack for ProLiant (SPP) from the Hewlett Packard Enterprise website

(https://www.hpe.com/servers/spp/download

https://www.hpe.com/servers/spp/download).

Procedure

1. If the server was previously configured:

a. Back up data on the system .

b. Close all applications.

c. Ensure that users are logged off and that all tasks are completed on the server.

CAUTION: In systems that use external data storage, be sure that the server is the first unit to be powered down and

CAUTION:

the last to be powered back up. Taking this precaution ensures that the system does not erroneously mark the drives as

failed when the server is powered up.

2. If the server firmware is not the latest revision, update the firmware.

3. If the new controller is the new boot device, install the controller drivers .

Installing a type-o storage controller

Prerequisites

Before you perform this procedure, make sure that you have the following items available:

Compatible controller cable

T-10 Torx screwdriver

About this task

Both OCP Slots 14 and 15 support the type-o storage controller installation.

CAUTION:

A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive

devices. To prevent damage, observe antistatic precautions.

CAUTION:

The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the server

when a port blank is removed without the corresponding I/O port option installed.

Procedure

1. Power down the server.

2. If installed, open the cable management arm .

3. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

4. Disconnect all peripheral cables from the server.

HPE ProLiant DL560 Gen11 Server User Guide

126