HP ProLiant DL560 Gen11 User Manual page 45

To power down the server, use one of the following methods:
Press and release the Power On/Standby button.
This method activates a controlled shutdown of applications and the OS before the server enters standby mode. It can also activate a
shutdown behavior governed by an OS configuration or policy.
Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter standby mode.
This method forces the server to enter standby mode without properly exiting applications and the OS. If an application stops
responding, you can use this method to force a shutdown.
Use a virtual power button selection through iLO 6.
This method initiates a controlled remote shutdown of applications and the OS before the server enters standby mode.
Before proceeding, verify that the server is in standby mode by observing that the system power LED is amber.
Open the cable management arm Open the cable management arm
Procedure Procedure
1. Press and hold the blue PUSH PUSH button on the retention bracket.
2. Swing the arm away from the rear panel.
Extend the server out of the rack Extend the server out of the rack
Prerequisites Prerequisites
Before you perform this procedure, review the Rack warnings and cautions.
T-25 Torx screwdriver—This tool is required if the shipping screws located inside the chassis ears are secured.
About this task About this task
HPE ProLiant DL560 Gen11 Server User Guide 45