Add Slides To Module - Leica THERMOBRITE ELITE User Manual

6. Using the ThermoBrite Elite Software
6.3.3

Add Slides to Module

The Protocol Dashboard is used to assign specimen slides to a Sample Chamber in one of three Thermal Modules.
There are three Thermal Modules; each contains two Sample Chambers, A & B. Each chamber can hold two slides.
A slide must be assigned to at least one of the Thermal Modules by clicking inside the first slide position.
The left chamber of each module must be selected first.
1. On the Protocol Dashboard, click inside the Module slide position corresponding to the location of your slides. The
gray area changes to look like a slide.
The area located below the slide diagram provides information about the slides that have been selected.
54
Figure 6-4: Protocol Dashboard—Empty Sample Chamber
Figure 6-5: Protocol Dashboard—Slide in Sample Chamber
ThermoBrite Elite User Manual
3855-7500-501 B02