Table of Contents
Advertisement
2. Introduction
The instrument's main power switch is used as the main disconnect device.
Observe Universal Precautions. Discard contaminated materials according to applicable regulations.
Dispose of waste product, unused product and contaminated packaging in compliance with applicable
legal regulations. If unsure of the applicable legal requirements, contact the local authorities for
information.
The Thermal Chambers may contain HOT liquid/reagent, handle with caution and DO NOT make direct
contact to HOT liquid/reagent. Wear Heat Resistant and Chemical Resistant Gloves are recommended
for hot reagents.
2.12 Leica Biosystems Contact Information
For service or support contact your local Leica Biosystems representative or see www.LeicaBiosystems.com.
2.12.1 CE Mark
The CE Mark signifies compliance with the applicable EU Directives as listed on the manufacturer
declaration of conformity.
2.12.2 Manufacturer
Leica Biosystems Melbourne Pty Ltd.
495 Blackburn Road
Mt Waverley, Victoria, 3149
Australia
2.12.3 Important Information for All Users
The term "Leica Biosystems" when used in text in this document refers to Leica Biosystems Melbourne Pty Ltd.
Due to a policy of continuous improvement, Leica Biosystems reserves the right to change specifications without notice.
Warranty claims can be made only if the system has been used for the specified application and operated according to
the instructions in this document. Damage resulting from inappropriate handling and/or misuse of the product will
invalidate the warranty. Leica Biosystems cannot assume liability for any such damage.
The intended users of the ThermoBrite Elite System are adequately trained laboratory personnel.
18
ThermoBrite Elite User Manual
3855-7500-501 B02
Advertisement
Table of Contents
