Leica THERMOBRITE ELITE User Manual page 27

3. Connect the USB communication cable provided to a USB port on the Netbook and to the communication port
located in the center of the back panel.
4. Press the ThermoBrite Elite power switch, located on the rear panel, next to the power cable, to the On (I) position.
5. When the instrument successfully powers up, a two-beep ready signal sounds, and the green LED on the right side
of the front panel illuminates.
ThermoBrite Elite User Manual
3855-7500-501 B02
Figure 3-4: Communication port located in the center of the back panel
Figure 3-5: Main power switch
3. Installation
27