Pad Condition - Nice HySecurity SlideSmart DC Series Installation And Programming Manual

PAD CONDITION

1. Follow the local building codes to identify the
frost line and determine the required depth of
the concrete pad. HySecurity recommends a
minimum 16-inch depth with a minimum 2-inch
extension Refer to Figure 2.
2. Before pouring the pad, consider conduit
placement so it fits within the confines of the
6.9 x 12-inch cutout in the SlideSmart as shown
in Figure 2. Run separate conduits for:
„ high voltage wiring (115/230V supply power)
including equipment ground
SlideSmart
operator
Chain
3 max.
Ground
(91.4cm)
wire & rod
Consult local
codes for
proper depth
Concrete pad
(depth set per
local codes)
High voltage wires
Main AC power
Grounding rod depth at
10 (3m) or per local code
18 18
support.hysecurity.com
Conduit runs
2" (5cm) above
concrete pad
Minimum pad
height is 2" (5cm)
Ground
above grade level.
lug
Low
voltage/Communica on wires
Cut-away
view
6.4"
(16.3cm)
.
10 5"
(26.7cm)
1.6"
(4.1cm)
Concrete
pad
Figure 3. Conduit View
„ Low voltage wiring (12V and 24V accessory
power)
• vehicle loop control wiring
• primary/secondary connections
„ Earth ground (NEC/NFPA)
3. Extend conduit height 2-inches (5cm) above
the pad (4-inches (9cm) above ground level).
Make sure the concrete forms are square with
the gate and the pad is level. The operator
footprint, with cover, is approximately an
18-inch square (4.7cm). See Figure 2 for the
minimum pad dimensions.
20.7"
(52.6cm)
Grade level
Vehicle loop
control wires
Extra conduit
(Dual Gate wiring)
(Conduit may be shared with low voltage wires)
Area
cut out
for
conduit
6.9 x 12"
(17.5 x 30.5cm)
10.4"
(26.4cm)
19" minimum
(48.3cm)
INSTALLATION
Chain, Gate
#40 Roller
21"
(53.3cm)
Slo ed holes (4x) for
concrete anchors:
½ - 13 x 3½"