Nice HySecurity SlideSmart DC Series Installation And Programming Manual page 66

Table 10. Smart DC Controller - Installer Menu Functions
Ref. User Menu
No. Display
EO 0 (STOP ONLY)
EYE OPEN LOGIC
20
GR 0 (FULL OPEN)
GATE EDGE LOGIC
21
SR 1 REVERSE 2S
IES SENSOR LOGIC
22
PC 1 NO CONTACT
PHOTO EYE OUTPUT
23
GC 1 NO CONTACT
GATE EDGE OUTPUT
24
66 66
support.hysecurity.com
Setting Options
(Bold = Factory Menu Tasks and Explanations
Settings)
Default setting is non-reversal if
0 = Open eye
open photo eye is triggered while
stops only
opening. A setting of 1 causes gate
1 = 2s reverse to
to reverse travel and close for two
close
seconds if triggered while opening.
Default setting is a full-open
reversal if gate edge is triggered
0 = Edge
while closing. Optional setting of
reverses full
1 causes gate to reverse for two
open
seconds if triggered while closing.
1 = 2s reversal
Gate Edge Open always reverses to
only
full close when all loops and other
inputs are clear.
Default setting is a two-second
0 = IES reverses
duration reversal if inherent sensor
full open
is triggered. Optional setting of 0
1 = 2 second
will cause gate to reopen fully if
reversal only
triggered while closing.
This menu item only appears when
UC is set to 4. Default setting is
photo eyes with Normally Close
0 = Normally
outputs. Optional setting 0 requires
Open PE output
a Normally Open (NO) output.
When set for NC, connection is
1 = Normally
monitored and any short circuit
Closed
fault will generate a FAULT 2 alert
(supervised)
which requires a STOP or RESET
button press to re-enable gate
operation.
This menu item only appears when
0 = Normally
UC is set to 4. Default setting is
Open Edge
edge sensor with Normally Closed
1 = Normally
(NC) output. Optional setting of 0
Closed
requires an (NO) output.
DISPLAY AND MENU OPTIONS
DC Controller
Display
Connections
Sensor Common
Sensor Input
Sensor Common
Sensor Input
(N/A)
Photo eye
connections:
Sensor Common
Sensor Input
+24V
Sensor Common
Sensor Input